#Pair logitech mouse software
Always good to have that in place! I launched the Logitech software and followed the instructions… but none of the two USB receivers were detected. Lucky for me, I had setup a VNC connection to my Z600, so I just logged in from my Mac and at least got control of Windows that way. I couldn’t access the Windows machine anymore either – so how was I going to start the Logitech software to repair this mess? The light on the mouse still came on, but the light on the keyboard (usually comes on when you press CAPS LOCK) was also dead. It was as if I had two dead devices on my desk. So I plugged the mouse USB receiver into the Windows machine too, and now NOTHING was working anymore – neither in Windows nor on Mac. The trouble was the keyboard was no longer detected on the Windows machine. And even when I switched on my Windows PC, the mouse was still working on the Mac. I was happy, modelling things in Blender (which is a little cumbersome with a Mac trackpad, or perhaps I’m just not used to it anymore). The good news was that when I used the original mouse receiver on my Mac, with my Windows PC switched off, everything worked just fine.
#Pair logitech mouse how to
So now I had to figure out how to UN-pair both devices again and put them back to how things used to be (before I started messing with them). I regretted pairing both devices to the same receiver and wished I hadn’t done that, for this very eventuality. But really, there’s only so much space on my desk, and I really don’t need more clutter in front of me for just an occasional switch. I know, it’s exotic, and perhaps I should have just bought another mouse.
#Pair logitech mouse windows 10
It all worked fine on my Windows 10 machine, until I wanted to use the mouse (not the keyboard) with my Mac. Turns out it was relatively easy to pair both devices to the same receiver, thanks to a small piece of software that can be found here, along with instructions on how to use it: Being an all-efficient belt-and-braces kinda guy, I tried my luck. Apparently you can connect up to 6 devices to one receiver and store any spare ones inside the mouse or keyboard. However, I heard great things about these little receivers and wanted to free up a USB port, and thought I’d connect both devices to the same receiver. I could plug both receivers in, and both devices would work great. I also had a Logitech M325 mouse, both of which came with Unifying USB receivers. I’ve recently bought a new Logitech K360 keyboard for my HP Z600 workstation.
0 kommentar(er)
